Can the M542 step motor drive generate the pulse signal?
Can be produced. Stepping motor is controlled by the input pulse signal, the total rotation Angle of the motor is determined by the number of input pulses, and the speed of the motor is determined by the pulse signal frequency. The drive signal is driven by the control signal, and the driver signal is the pulse signal, which then controls the rotation of the motor.
Check the information on this drive, which is completely unworkable. If it's just a switch, if the motor is spinning, it's not as good as a dc motor. Vibration, noise, torque, and speed are better. The step motor is designed for precise control of the Angle of position, and it can also be convenient for controlling the speed and turning of the speed, which require digital signal to complete. If just to rotate, do not need to locate what of, have to at least one pulse generator, frequency cannot too big, combined with fine scores determine, without segmentation, probably hundreds of this level, had a breakdown on the fine fraction. You still need to debug, the higher the frequency, the faster the motor will go, but it will not move when it is too high. General need high speed rotating, using single-chip microcomputer and PLC control acceleration, pure no acceleration pulse signal control, maximum speed is not too high.
Drive itself can not produce a pulse, you can focus on our products, you can have an independent control mode, the built-in PLC, thus have I/O mouth logic control, well, not advertising, I don't think a single drive input words can only in this way, your information is sent to me
The step driver needs to have a pulse signal, because it's going to be precise, otherwise it's going to be a normal motor. The simplest way is to get a 555 pulse
Drive itself can not produce a pulse, you can focus on our products, you can have an independent control mode, the built-in PLC, so there is logic control of I/O port The step motor drive is an actuator that converts electrical impulses into angular displacement. When stepping drive receives a pulse signal, it is driving a stepper motor according to set the direction of a fixed Angle (called "step Angle"), its rotation is based on the Angle of the fixed step by step. It can control the amount of angular displacement by controlling the number of pulses, so as to achieve accurate positioning. At the same time, the speed and acceleration of the motor can be controlled by controlling the pulse frequency to achieve the goal of speed adjustment and positioning
