Home > categories > Measurement & Analysis Instruments > Pressure Sensors > Can the MITSUBISHI FX2N series PLC pressure sensors be connected directly?
Question:

Can the MITSUBISHI FX2N series PLC pressure sensors be connected directly?

Can the MITSUBISHI FX2N series PLC pressure sensors be connected directly? I need to measure the weight of paper packaged milk products on the production line. What type of pressure sensors should be used? Can take down the wiring diagram?

Answer:

You should not use, but the pressure sensor, weighing sensor, not directly into the PLC, previously used, that is used in transducer matching, and then output the analog signal into PLC, so you need to have a grand pan analog point.The specific model determines the range and accuracy of the sensor according to the weight you actually measured
Weighing sensors, a lot of products, look at sample selection
PLC adds analog module FX2N-4AD, with 4 analog inputs.There are two modes of wiring, one current type and one voltage type.The ranges are 0-10V and 4-20MA, and your sensor outputs the signal corresponding to this.Specific, you have to look at the manual, the wiring is finished, there are procedures, manuals, very detailed.

Share to: