Car seat cover pattern making process?
Manufacture and installation of leather seat cover.Making leather seat cover is mainly divided into eight steps: demolition, plate making, tailoring, sewing, package, run piece of chair, plastic and back seat.
When the board is finished, you can cut the leather. The whole leather tile on the board, first check the leather, found the damage place, should be to pull off, avoid the skin cut here. Spread the finished cardboard on the leather and cut the leather along the edges. According to the number marked on the board, cut out the corresponding number.
The system board, is in accordance with the original seating type and style, the various parts of the seat cover for extension plate.First of all, the name, in the original car seat cover note site and the number of markers. Then, according to the sleeve seams cut. Note: to put the seat cover around the circle cut down stereotypes, we will use the new seat when stitching. A seat in the front, usually by plane, plane, front and rear wall, two side and two side of a total of nine parts.
Close the key door of the car before you remove it. Take out the special tools for car maintenance and remove the fixed screws from the driver's seat. First remove the screws from the front of the seat, then to the back of the seat and then remove the two screws at the back. Then you can push the seat back, then lift up your seat and pull out the seat belt. The seat can be taken from the car. The seat driver's seat is disassembled the same way. When removing the back seat, lift the cushion to the outside of the car first, then recline the backrest, remove the screw, and the backrest can be taken out of the car. There are not many techniques for removing the seat. It only requires the operator to be light and avoid damage to other parts of the vehicle.
