Wired car radio no sound powered on then wires crossed had to run red straight to battery. Then memory and ground crossed. Now nothing. Checked fuses radio fuse is bad. Will i also need a new wiring harness? Stereo Works fine when hooked up to battery charger.
Yeah i had them all wired together right i didnt tape them off cause i was trying to see if there was a bad speaker or something and.the.ignition wires hit.the.ground so i ran it straight to the battery cause i thought the ignition wire shorted out in harness then i was told to check radio fuse.
Could you rewrite your question and clear it up some. The red wire should go to the ignition on the existing harness in the dash. You were crossing all of those wires? Look at the diagram that came with the deck to know which wires go where. Typical pairs of wires (white and white w#x2F;black stripe or gray and gray w#x2F; black stripe) are for the speakers, red is for power(ignition) I think green is the signal wire and so forth. I don#x27;t know how your wires just get crossed like that? Did you splice them into the wrong ones in the dash?
