Causes and inspection of ice making in ice maker
Five, ice machine leakage 1, the water inlet valve to supply water is too large. 2 、 the connection pipe is broken. 3, fault. 4, water level float valve fault.Six, noise is too big, 1, ice maker fan fault. 2, reducer fault. 3 、 compressor noise.Seven, water shortage alarm 1, water supply joint filter screen plug. 2, water pipe plug. 3 、 inlet valve block. 4 、 drain valve leaking. 5 、 water pump failure.Eight, boot system failure 1, phase sequence problems. 2, the power supply system failure. 3 、 control panel fault 7
Two, ice production reduced by 1, capillary or expansion valve plug. 2, the system moisture is too high, there is a slight ice jam.3, ice machine condensation system is blocked. 4 lack of refrigerant or leakage. 5 、 the evaporator is dirty.Three, wet Bing Bing film is not hard, 1, environmental temperature is too high, especially in the summer will have a kind of situation.The machine repaired 2, add refrigerant. 3, ice separator water supply is too large. 4, press power shortage.Four, the machine running, but not out of ice, 1, water disk water is not enough or anhydrous. 2, reducer failure or deceleration motor.3, system failure, ice jam. Dirty block, etc.. 4, ice machine leakage of snow, the pressure is not enough, 5, ice thickness is not enough
Causes and inspection of ice making in ice makerNote: first, compressor intermittent work: 1, the voltage is too low. Check the power supply.2 、 handing over contact is not good. 3, system pressure protection. 4 compressor starter fault. 5, condenser is dirty, high voltage protection.
