I opened the door of the CD-ROM can not open, only with fine wire poke about the door to open an emergency hole in order to open the door, every time this is how to do it?
Strange ah, if the CD-ROM drive, CD-ROM can open it!
It is hard to solve, for the new bar, my drive is also the case, had thought that can be used, and now has to die, because sometimes in the motherboard self-test when the drive that card, after taking the self-test immediately through
Not the optical drive aging or the use of frequent ``
It is recommended to go to the computer shop to repair the following can not spend much money
Why Internet cafes do not have optical drive `` `is the use of this thing should be frequent or not long use will be the old` `shell so that` ``
There is a certain discipline will open sometimes natural unnatural suddenly opened the `` `
I hope you wait for a day `` If you are advised to use the line with the card to be used in the time to open the `` `But this is not a long time` `
Recommended repair
When you press the "exit" button on the CD-ROM panel, there is no sound in the CD-ROM "slightly deng" about the sound, yes, in all the drive is connected to the optical drive device out of the belt loose, or belt Slip caused by.
How to handle
With a song pin, pull it straight, if the hand is not yet, can also be used sewing needle, to be thick, it is best to set the kind of quilt, in turn, do not take the needle tip.
In front of the optical drive class, look carefully, there must be a small hole, it is emergency pop hole. Press the "exit" button at the same time, the paper clips from the pop hole with a little bit of force into the plug, the top of the drive tray will pop up. Try a few more times.
How to repair?
Need to take out the drive from the chassis, open the upper and lower floor of the drive, the panel is the use of two plastic card tenon card into the tongue on both sides of the button, push the direction of the tray to push, you can withdraw from the front panel, The tray will be pulled out in the end, you can easily see the tray into and out by a motor through a small belt to drive the plastic gear to achieve rotation, the conditions can be removed from the old drive with a belt Put on, or use to increase the belt of the belt pulley friction, you can first remove the belt, with electric iron, a few times in the pulley out of a few grooves, and then put the belt up, so that increased The pulley drives the friction of the belt. After such a deal, generally can solve the problem.
Need to remind you is: If your drive is still under warranty, do not open the CD-ROM unauthorized, that will destroy the warranty label, and thus lose the warranty. But should be repaired, make full use of your rights.
If you do not want to start, you can drive to the computer market to repair, such maintenance up to 10 yuan.
