After taking off the old one, I noticed there are 3 different wires coming into the bracket. One looks like it goes to an outlet, or the breaker. One goes to the switch, and one goes in the direction of the kitchen.There is a single black that was connected to the fan, and that was it. All others were capped off. Now two blacks and a white were pigtailed with each other, while the other two white were pigtailed together. My question is: How do I install the fan?And why are these wires all over?The house was built in the 70s if it helps.
ok - that sounds slightly unusual actually the owner (are you renting?) has duty to grant authorized and risk-free living? in case you very own, then your community council will examine, and help rectify probably unsafe wiring. positioned in simple terms, the Earth is there just to guard you from being greatly surprised if the casing of the fixture ought to alter into stay. it particularly is why the fairway/Earth oftentimes attaches to the gentle setting up, and to no longer the gentle itself. to respond to your questions: a million. you are able to set up it. it particularly is slightly risky, yet how low is the ceiling? If it particularly is way extreme and not going to be by risk touched, then no real concern. additionally if the casing is plastic, no longer metallic, you would be safer. yet i think the fan veins are metallic(?) 2. you additionally could make an earth via working an earth twine to the setting up from the different Earthed region. usually each and all of the metallic fittings interior the washing room would be Earthed - so radiators / pipes / bathtub / bathe. in case you have get right of entry to to sufficient of the ceiling areas to run that twine, you additionally could make an Earth. How elementary relies upon on the form of the ceilings and the format of the home. individually, i might in simple terms set up without an Earth. in case you install it properly, there is little risk of you desiring the 'lower back-up' of the Earth connection.
I believe you have a lighting circuit that is coming into the box and leaving the box. The other cable is going to the switch. First, it is best to takes notes as you take something apart. The two blacks with the white is your hot, with the white going to the switch. This is called suicide switching. The other two whites are the neutral. Attach the black and red wires from the fan to the black wire that is by itself. This should be paired with the white wire that is spliced with the blacks. This is your switch leg. Attach the white from the fan with the other whites. Make sure all your connections are tight.
