About operation order of Pegasus drilling rig1. remove the data (click on the top left corner to start the new document)2. open the new band (click the upper left corner of the open file)3. parameter settings (click parameter settings)4. click the default (click the default below the parameter interface, and the slot needs to be slightly adjusted to slow down)5. set the tool library (F5 refresh library, and then set the life <3000>)6., adjust the zero point (before adjustment to zero), "ctrl+w" by cursor key adjustment, after adjustment need to confirm
, confirm OK after zero control tool7. compare the cutting tool (take the process card and tool control card, compare the cutting tool parameters, confirm the data later)8. save the data (click on the top left corner of the save edit file, save to the D disk)9., all processing (F4 all processing)
