Cold cutting bag machine how to adjust the knife
2. When the use of a period of time after the plug iron gap increases should be immediately adjusted, then the first release of the nut, a little plug into the plug iron adjustment screw to the appropriate gap so far, and with a spike check, the gap should not be greater than 0.02mm
1. When the knife on the line to the bottom deadline, and the knife should be completely closed left and right, such as the right side has not yet fully closed, the adjustment should be adjusted rod nut, so that the knife down slightly, after adjustment, the pin on the nut.
Pull the paper at both ends of the degree of compression, until about equal. After adjustment, to lock the nut to prevent loosening.
In the bearing seat pad with a thin paper, hand-rotating body box within the big hand wheel, so that the welding knife at the bottom dead center, loosen the nut, adjust the nut (Note: rod adjustment nut factory basically tune), hand
3. Adjust the upper knife adjustment section of the screw, the use of the knife edge and the lower edge of the cutting edge has a small length of the gap, in order to prevent the occurrence of knife phenomenon damage tool.
