I have speakers from the JVC unit SP-HXZ30, and I want to hook them up to my new Yamaha RXV367. The speakers have four wires each, how would I connect both speakers to the receiver?
Depending on the type of recover you should have 4 posts sticking out for wires. You would connect the red from the speaker to the Red on the receiver and ditto with the black wire. Do this for the left speaker to the left output from the receiver and do the same for the right speaker. Then tweak your reiceiver to your liking, then again you can also just check the owners manual
I connect my MAC to my stereo receiver by potential of potential of its headphone/audio out output with a headphone plug at one end and a left (white) and appropriate (crimson) RCA plugs on the different. ONE observe OF warning! in case you power the computing device from the wall, you would be able to get an extremely loud buzz interior the audio . Why this occurs, I have no thought. If that occurs, bypass to Radio Shack or suitable purchase and get a floor loop isolator. I had that difficulty with mine. while i discussed it right here in yahoo solutions, a responder advised me approximately this answer. Now, I surely have very nearly no noise in any respect.
Ok, this may be a bit complicated so pay attention. There will be a quiz at mid-term. What you have here are three way speakers. There is a woofer, midrange and tweeter. The subwoofer is really just a woofer. Unfortunately for you it is not set up like a normal three way speaker. It is set up to be bi-amplified. What JVC did was they included a separate power amplifier in this system to power the subwoofer. That is why there is a separate input for it on the back of the speaker. In addition there is a filter in the main unit of the JVC that filters out the high and mid range sounds for the subwoofer amplifier. This is a problem as you are now using a Yamaha receiver instead of the JVC main unit. The Yamaha does not have this feature. These are the options: 1. Just use the top speaker terminal for the midrange (woofer) and tweeter: It won't sound very good. You will get little to no bass. 2. Jump the upper and lower speaker terminals: Highly inadvisable. As each section is 6 Ohms you will wind up with 3 Ohms and that is likely to be too low for the Yamaha receiver. It won't damage it, it will just go into fault mode and shut down. You will also have distorted midrange and highs coming through the woofer. 3. Get a subwoofer amplifier to power the bottom of these speakers and connect it to the subwoofer out on the Yamaha: A silly option really. This would cost as much or more than just getting better speakers. 4. Get better speakers: This is the best option. Those JVC speakers are plastic boom box speakers and are not nearly the quality of the Yamaha receiver. Use option #1 until you get better speakers.
