Home > categories > Minerals & Metallurgy > Copper Pipes > Copper supply plumbing touches steel drain pipe. What can I do?
Question:

Copper supply plumbing touches steel drain pipe. What can I do?

Remodeling a house and found a copper supply line contacting a steel drain pipe in the wall. Copper which contacts steel will corrode. What can I insert between the two pipes? Electrical tape? Small piece of rubber? Foam pipe insulation sleeve?

Answer:

In new construction, thin sleeves of polyethylene (like trash bags are made of) often are used to prevent 2 pipes from touching. It doesn't take much, you just need to prevent electrons from one pipe from going to the other (as water flows through, it creates tiny electrical currents which will try to electroplate one pipe with metal from the other), and it must stay in place. I'd say wedge a slab of thin foam rubber between the two and duct tape it to hold it in place.
Bend the copper pipe or use a cedar shim. Either a bad install or the walls have shifted. Pipes do not normally touch except for the previous 2 reasons. Proper fix is to reroute it around the steel/iron/lead pipe.
The best answer would be to re-route the copper pipe around the steel pipe. If you don't have a tubing bender to fit the pipe, you can get a piece of soft copper and bend it by hand to get around the steel pipe. If you don' t have access to soft copper, you can use a 90 degree elbow with a 90 degree street elbow to jog around the interference. The use of too many elbows is not the best system, so use good judgment. Using a shim or even wrapping the copper pipe with pipe wrap tape is not a long term solution.

Share to: