Dark line pvc line tube unreasonable how to do
absolutely okay. If it is not more than a floor or 100 data points, then there is no need to not use patch panels. In other words: patch panels only apply to commercial building wiring. Home wiring can completely abandon it. In addition, the network patch panel can be replaced with cheap 110 patch panels. Each 100 pairs of 110 patch panels can also be terminated 24 information points.
Small cabling system can, but this is not a regular way of wiring. The shortcomings of the patch panel is: the network RJ45 connector is a life, if the bad quality of the RJ45 head time is a little longer to be replaced, so there is a connection between the information points and switches between the cable is shorter and shorter Until the switch position, but also to re-line; and without the result of the cable is the entire cabinet jumper like a waterfall hanging between the patch panel and switches, if the tie with the jumper tied up, then for The future maintenance of the impact of regulation is very large, so the formal integrated wiring project or to use these accessories are good.
1. To the hardware store to buy two 18 # thin wire, the length of the wire tube to the other end of the distance, plus 2 meters. First one of the two wires with a wire clamp to bend a small hook, a hook with a wire into the wire tube, until the wear. And then another hook with a wire from the other end of the line into the mouth, according to the length of the first penetrate into the root, while the edge of the wire to do 360 degrees of rotation, according to feel or sound to confirm the two wires have been After twisting, slowly pull out, to the other one to bring out. (Brought out of the head of the head out, with another root from the line, can not pull out too much). And then hang the wire to the left of a wire, tighten, from the other end of the wire slowly pulled out to pull the wire out to stop. In the process of pulling out the wire or wire, the best someone else from the other side of the delivery, the two will be much better with the effect. 2. Determine the direction of the wire tube, with the wire to the blocked position, in the wire to do the mark, pull out the wire, according to the length of the block to find the approximate location, and then cut the wall or ground inspection. Repair the wire tube, into the wire after the repair decoration. In the absence of a certainty whether the wire tube is really blocked, the previous method should be tested several times, and the method 2 should be used again.
If only home furnishings one or two cable or can, if there are more than 100 square feet of each room to the Internet, watching TV, it is possible to install monitoring, automatic control of the electrical or a cell unit of the integrated wiring system, it is necessary to install Patch panels and cable organizers.
