The construction of the people say to make a certain slope, because the rain to the direction of their own home to the flow of the station
Will the beam be loaded with I-beam? Workers say 50 * 100 square tube on the line
Recommendation: do the sun room must choose a regular company, need to have the design and calculation capabilities, through the design of the design calculation to ensure the safety of the structure, which is necessary. There are regular company material control will be better, construction and installation will be more standardized after use, with the rest assured.
Slope is necessary, is conducive to drainage, more importantly, in order to ensure that the top surface of the ash can be washed away with the water, the slope should not be too small.
Load-bearing rod (beam, column) according to the structure according to the standard calculation to determine, as long as the satisfaction on the line. In general, the use of aluminum alloy structure, the latter there is no anti-corrosion problem will be better, if not a large structure, it is recommended to use aluminum alloy material (the surface of the use of spray color selection, corrosion good weather). The general home decoration to do the sun room area will not be too large, aluminum alloy structure is preferred. Most people always think that steel structure than aluminum alloy structure is safe, it is a misunderstanding, the aircraft is mainly used in aluminum alloy material, so the material is not a problem, the key lies in the choice of section of the bar. Aluminum alloy material is easy to form, according to the need to open a model, select a large range, and aluminum structure can make a variety of sunny room modeling, beautiful and practical!
Two ways no problem, the key is to practice norms.
However, do the best sun do not use 12mm tempered glass, according to the norms should be used laminated glass, PVB film must be used dry clip, and the film thickness of not less than 0.76mm (two film). If you want to use a single layer of tempered glass and not more than 8mm thick (to reduce the power of glass burst fragments wounding), glass strength can be reduced by reducing the size of the plate.
