I used my aluminum tube to make a "Feng" type outdoor antenna, and all the aluminum tubes were connected together. I now have a small piece of aluminum plate, the aluminum plate should be installed in the "Feng" rack in what position, is connected together or insulated from each other?. If all of them are finished, how can the coaxial cable be connected, and the middle axle connected to the "Feng" rack or the aluminum plate?If I can't do this project, then what kind of outdoor antenna should I make for these materials (aluminium tube and aluminum plate)?Thank you all! StopThere is no shop in the place where I am now. Please don't tell me to buy one.
Do you put the word on the two Feng antenna cross to two is not the word Feng head, then use your remaining thin aluminum plate is cut into two cm wide and fifty cm long aluminum bars then bent into a rectangular five cm wide, 1 cm in the opening distance, with openings on both sides core matching after coaxial cable connected, then it will be fixed in the middle of Feng below the word of the two cross, finally across the antenna on the four directional antenna unit. I wish you success in your production.
Homemade antenna is very troublesome, and the effect is not good, it is better to buy a ready-made, not expensive, if you are not afraid of trouble, I can tell you specific methods.Do you put the word on the two Feng antenna cross to two is not the word Feng head, then use your remaining thin aluminum plate is cut into two cm wide and fifty cm long aluminum bars then bent into a rectangular five cm wide, 1 cm in the opening distance, with openings on both sides core matching after coaxial cable connected, then it will be fixed in the middle of Feng below the word of the two cross, finally across the antenna on the four directional antenna unit. I wish you success in your production.
Homemade antenna is very troublesome, and the effect is not good, it is better to buy a ready-made, not expensive, if you are not afraid of trouble, I can tell you specific methods.
