Engraving machine in the tool after the three axis cleared, then open the machine, Z shaft why rose to limit switch?
The main shaft reversal phenomenon of woodworking engraving machineWoodworking engraving machine in the work process, the engraving machine spindle inversion, because the frequency converter connected to the main axis of the wire counter, and casually change two can turn right.When the main shaft is reversed, if the engraving density board, there will be a bad knife, the knife on the safe and then may be broken. Sometimes, if not broken, will be burned red, so this abnormal phenomenon occurs, stop, check the main shaft.In the woodworking engraving machine used in production, how to avoid the mistake of carving production, is a lot of customer concerns, because often because of carving a path set wrong, or prone to error, carving error, error is the result of a waste of sheet metal, which is a huge waste, because many customers use plate is very expensive, there a little bit wrong, it would be a waste of the entire plate. Therefore, how to avoid woodworking engraving machine engraving error is a common problem we face, in this engraving machine manufacturers tell you a trick, use the control system to avoid woodworking engraving machine engraving error.
The motor feels so weak that it can not move:Solution: check the circuit, check whether the motor line is missing, or whether the cable is short circuited.
Analysis of common faults in main shaft of woodworking engraving machine:First, woodworking engraving machine spindle motor hot:Solution: first check the pump is working, but also to see whether the lower level of circulating water.
