F-type - assembled skeleton rock wool board protective layer for the fiber reinforced calcium silicate board 05J3-1-F-type external wall insulation operation method This is what work method
The system uses rock wool board for insulation layer. The rock wool board is pressed against the surface of the base wall by the steel wire clamped by the anchor, and the rock wool board is pressed.
??? Flat layer, the protective layer is embedded with alkali-resistant fiberglass mesh reinforced polymer cracking mortar, is a thin plaster layer, paint finishes.
Rock wool board specifications for the 1200 * 600mm
?? Yanmian board where the surface is not intended to improve the surface strength, water resistance and bonding performance of the surface treatment, it should be in the rock wool board and wire mesh installed and fixed, the board spray sandblasting interface agent
Rock wool board wiping the insulation slurry, mainly on the rock wool plate surface from the leveling effect, the technical performance of the insulation slurry and the layer outside the role of anti-cracking waterproof protective layer,
??? The facing layer is the same type B system.
Anti-cracking mortar in front of the hole in the hole should be paved with additional alkali-resistant glass mesh,
? Anti-cracking mortar protective layer construction, should be in the insulation slurry leveling layer after the full curing.
When selecting this system, you must abide by the requirements of the Atlas.
? Grass-roots walls should be solid, flat, (masonry wall of the gray seam should be flattened) protruding objects should be removed and leveling.
When the rock wool board is laid, the rock wool board will be temporarily fixed in place with an anchor, and each rock wool board should have at least two anchor points, the slit shall be squeezed,
?? The width of the slabs shall not be less than 150 mm and shall have at least one anchor point, at least three anchors shall be provided on each side of the window.
