Faucet to open the water heater why not fire
May be because the kitchen faucet water is small, that is, water speed is small, water heater sensor switch sensitivity is low, it can not be normal ignition. So every time you use, quickly open the faucet to the maximum, or at the same time open the other faucet, after ignition in the transfer to normal.
But the kitchen from the electric water heater pipe long water pressure is small, the beginning of the water fretting did not open, there is also a kitchen faucet out of the hot water there is a clogging of the dredging cut off cut the dregs of dengling japonica down to the small amount of water, See the hot water pipe to remove the hot water faucet
Take the filter on your faucet in your kitchen and try to get rid of it. Because other faucets can be used normally, a problem is that the water is too small. Wish smooth.
Water heater can not hit the fire, there are several reasons: First, check the battery if there is electricity, if the battery is no electricity, then the performance of power failure or no fire, replace the battery after the general can be resolved. Second, the water pressure is too low. Now the gas water heater can be low water pressure start, but if the water pressure is too low, then the water and gas linkage valve will not start, the performance of no ignition. Of course, the water at the filter plug can also cause the water flow is too small, just clean up. Third, the water vapor linkage valve water pressure diaphragm aging. Hydraulic membrane aging loss of elasticity, it will cause the slider is not flexible, then even if the water pressure is normal, the gas will not pass, the performance for the first time can be used normally, but the second use will be separated by a period of time and so on Block normal reset to fire, or simply can not fire. Fourth, the flue is blocked. Flue obstruction will cause high-temperature exhaust row does not go out, resulting in return pressure, resulting in failure of ignition, we can according to the fire situation and the amount of exhaust gas to determine the size of the general can be clear after the normal ignition. Fifth, the air pressure is not normal. Natural gas pipe network pressure is normal, but the gas tank is not necessarily, the gas pressure is too high or too low will cause no fire, adjust the liquefied gas valve or replace the rubber mold.
