How to weld the belt on the belt conveyor belt broken, and how to get the most reliable?
If the drive belt is long enough to overlap and then drill holes are tightened with screws
Manufacturers have a special tool ... two electric mold a total of two, first of all to the broken belt to deal with both ends, and then power electric heating mold, the belt on the middle of two molds, heating ... ... not too long, half Hours on ok
To use a special spot welding machine, the belt first transferred to the most loose, and then the two fractures are cut flat, burr clean, and then stacked together, stacked length of at least 2 cm or so, both sides with large forceps and the like Tool clamping, careful not to stack off, and then welding a few points fixed to see if there is no problem, then straight line welding, as far as possible a little solder, welding and processing interface after the edge
