Glass insulation film how to paste?
A tool
Need the tools, knife, scraper, ruler, detergent, water, towel, pen
Second, the film steps:
1. Cutting film (according to the glass size of the glass film cut, should be slightly larger than the glass 1 cm above)
2. Wash the glass to thoroughly clean. Multi-spray point of water, with the film scraping scraping several times, so that the glass without shredding dust without sand.
3. Spray water on the glass After washing the glass and spray a layer of water on the glass.
4. In the film is also sprayed with water to protect the film and film separately, in the film surface of the glue also spray water.
5. Scrape the water between the membrane and the glass with the film scraping the water inside the slowly scrape out the scraping, repair the extra film corners.
After finishing the feeling of more than glass "turned success", even the whole family are a lot of beautiful ~ ha ha ~ [recommended to find a professional master paste, the effect will be much better Oh!
Third, note:
1, can not tear the adhesive tape too much, can only tear a little, it is best to tear from a corner, and then paste the corner of the glass and then slowly a little bit of tape, a little bit Affixed to the glass.
2, before the paste must be wiped the glass, we all know, but also the best in the clean glass spray on the water, so that the glass film will not stick to the glass.
3, sometimes will produce bubbles, if the glass film is always lifted and then re-posted, the result is often getting worse, in fact, this time as long as the needle with a bubble puncture on it.
4, while the paste, the general use of large brush brush cellophane on the surface, it is easy to paste the docile.
