Gypsum board ceiling, when digging holes, and installation should be noted
Of course, before the paint hole ah, be sure to open a good, do not be big and not small! There are openings
Finished and then paint, latex paint and then install the lights!
As long as the lamp position can be set to open the hole, and then putty putty, and then brush latex paint, and other latex paint dry, and in the installation of lights.
My house is finished brushing the hole before the opening of the lamp, because the lamp cup has a narrow point along, burr can block, does not matter.
Note the following:
Digging holes should be based on the size of the diameter of the downlight to dig, too large or too small will affect the use and beauty;
Digging the hole position should be based on the location of the design to locate, that is, the layout of the lamp box position, can not offset the aisle will lead to late light line is not enough, can not access downlight.
Dump the end of the hole when ready to wiring, it should be taboo to close the house under the headlamp line switch to prevent electric shock.
After the end of the overall renovation, to the installation of the project can be tapped when the hole.
