Have you used the marble tiles, the quality, the price?
Specifically, the selection of floor tiles can start from the following aspects:
1. To see whether the color of the tile body is pure. Mainly observe the back of the tile color is uniform, consistent.
2. To observe the tile cross section of the particles are delicate. Here the cross section does not refer to the tile around the cutting surface, but refers to the broken tile tile. In general, the fracture at the fine, hard and brittle, the same color for the top grade. Because the fine grain tiles waterproof ability, and the larger particles of the tile, the water is easy to immerse, affecting the quality.
3. Pay attention to the thickness of the glaze layer. Glaze thickness is the thickness of the glazed cross section. Glaze is the most expensive material in the tile cost, the thicker the glaze, the better the quality.
4. Listen. Tapping the tiles to pay attention to hear the sound is crisp, such as the sound clear, sweet for the top grade, such as the sound boring for the defective.
In the choice of floor tiles, the focus should be considered such a few aspects: First, look at the brand. Only the well-known brands of floor tiles, the quality of its building materials to meet the national standards, the content of harmful substances in the safe range. Second, to see its anti-fouling ability, if the family are very busy, two or three days to clean a health, it would choose to better defrost capacity. Third, if the home has the elderly and children, then the purchase must be made about non-slip test.
5. Try the water. Consumers can pour some water on the back of the tiles, pay attention to observe the speed of water absorption of tiles. After a few minutes, look at the positive water left the mark is obvious. After the water is spread, the density of the tiles is so long, and the water is not obvious.
6. Warping. Take two brick back to the back and face to face to see whether it can be in close contact with the phenomenon of excessive gap can determine whether there is warping.
7. infiltration. Find ink painted on the surface after 1 hour after scrub to see if there are traces, no trace is a good brick, there is a strong choice of infiltration.
