Home > categories > Minerals & Metallurgy > Aluminum Foils > Help Me Solve This ChemProblem PLEASE HELP metest tomorrowi beg you?
Question:

Help Me Solve This ChemProblem PLEASE HELP metest tomorrowi beg you?

the problem reads quot;a sheet of aluminum foil has a total area of 1.000 squareft and a mass of 3.937 gWhat is the thickness of the foil in millimeters? (Density of Al 2.699 g/ cubic cm.)_ mmso you have the density and divide by the mass.identical units cross out, you are left with volume - which is divided by surface area adn gives you thickness.so it's 2.699g/cubic cm / 3.937 g you get 0.6855473711 cubic cm x 10^3 you get 685cubic mmthat divided by 1000 sqft (or 92, 903, 040 square mm)and I got 7.37 x 10^-6but hte computer say answer is wronghelp me.

Answer:

you wrong here {so it's 2.699g/cubic cm / 3.937 g you get 0.6855473711 cubic cm x 10^3} you must divide the mass over the density to get the volume I mean 3.937 g / 2.699 (g/cm^3) 1.455 cm^3
Yes you canWarning.Foil transfers heat rapidly and can burn your lipsUse it as the bowl part only.
A vaporizer is a device for smoking herbsIt uses a heat source to heat the herb If marijuana is heated from 338 F to 372 F, the THC vaporizesThis is not hot enough for it to burn so it does not produce as many of the Heated tin foil is not a healthy thing to breathe, so the suggested bowl would be .
Don't Smoke Out Of Tin Foil It's So Bad For YouIt gives you Alzheimers and its bad for you brain besides thatI smoke the budz for a longggggg time Just go buy a 5$ pipeOr Smoke out of an apple.
No dumbdumbWell if your talking about wrapping it in tin foil.but I highly doubt you are because that would be stupid hahaJust look up home made bowl on youtubetinfoil,any type of bottle, lighterLight a hole into the bowl like a few inches down from the top, (small hole), put like 2 inches of water in the bottle, put tinfoil at the top (where you drink from, make sure it has a little indention, so you can put the weed in it), and poke holes in the tin foil with a tooth pick or safety pin (not to far apart from each other, and poke about 10 or 15 holes.

Share to: