i already tried wiring this light, but it didn't work. I always thought black wire to black, white to white and ground to ground. i connected the light fixture black wire to the three black wires (as shown in image) and the light fixture white wire to the three white wires, and connected ground wires together.when i flipped on the breaker, the light came on with the switch on off and the breaker tripped. i'm assuming this is wrong and i provided an image as i see in my ceiling mount. Can somebody kindly direct me how to properly connect the light fixture to these wires. thanks!
without seeing the ceiling fixture container and wiring myself, i may well be hesitant to propose you as to what the greater wires are for. I anticipate which you mean the sector on the ceiling has those wires in them, not the ceiling fixture which you obtain, on account that that could have had a wiring diagram that explains what the wires may well be for. If I had to guess, i might say that the sector contains 3 wires because of the undeniable fact that it is going to have had a ceiling fan that operated on a various substitute than the easy, or possibly the easy is additionally controlled from 2 particular switches on unique aspects of the room, or may well be the two one in each of those. Do you have gotten an AC voltage tester to verify which wires are sizzling (stay) and which at the instant are not? I hate to propose this, although by potential of and massive your great wager is to conform with the wires back to their source to look what they're for. Do you have gotten a faux ceiling you are able to open up? Do the wires pass into the attic or crawlspace the place you ought to look at them jointly as not having to tear open the gypsum board or plaster ceiling? you ought to easily positioned all the whites mutually and all the blacks mutually, and verify the grounds are in place, hoping they have a reason. although now not information what they're there for is a sturdy thank you to rationale an electric fire. and that i'm specific doing that could now not be authorized via your close by electric development codes.
Depending on how your light and switch are wired, there could be a couple of different combinations. If you have more than one set of black and white wires, you have power coming into the box and carrying on to another outlet. I'm going to guess that your switch will only have a single 2-wire connected to it (one black and one white - plus ground). If so, you need to figure out which one of the cables at the light box, is going to your switch. Once you've figured that out, splice the white wire from that cable, to the other two black wires. Splice the other two white wires together. That leaves you with one black wire by itself. Connect your lights to that black wire, and the two whites. If you have something else at your switch, you will need to provide that information before I can give you an answer.
This should have worked. Any chance you have one of the black wires touching the side of the box or one of the white or ground wires? If the fixture that was removed worked before the new one should work now. Also check that one of the screws holding the fixture didn't touch one of the black wires when you tightened it. .