Home > categories > Home Appliances > Electric Kettles > Hemisphere hot kettle after the plug, no reaction, open, look at the base, what is good. It's still in the morning.
Question:

Hemisphere hot kettle after the plug, no reaction, open, look at the base, what is good. It's still in the morning.

Hemisphere hot kettle after the plug, no reaction, open, look at the base, what is good. It's still in the morning.

Answer:

Look at the base, the needle and the site. Is that contact loose?
The electric kettle is mainly a heating pipe (inner heating wire is poured into the tube and surrounding insulating aluminum oxide powder and quartz sand or outside) a series of temperature protection switch (about 102 C) to prevent dry burning without water, resulting in the center of the base, the kettle is inserted interface of AC 220V power supply, kettle take down, leave the power supply, electric kettle is the most simple way is complex and add some protection measures, or. Bad, and find someone to see if the heating tube broken wire, did not burn, that is, other failures, cost little, good repair. When the wire is broken, there is no need to repair it, because the heating tube is mostly connected with the kettle body. The heating pipe is out of circulation, and it's not as good to repair. Temperature protection switch is generally not bad, plug interface sometimes bad contact, find contact bad reason.
Open the base in the middle line and then a sheet of the screws removed, then the vertical iron breaking direction, this electric kettle under the iron can touch the iron, can boil water. Clean it if there is red rust on the iron sheet. If not, the copper wire is broken, or the button on the kettle, the button can not open there, you can only buy a new one,

Share to: