Demolition of this step will not be demolished, the place where the water is a leading two into the water pipe connection, online and other issues added: more
The lower part of the lower part of a screw clip folder, first high-pressure hose connector screwed off to remove, and then the top by the hose part of the screw off, you can remove the faucet
First turn off the corner valve switch with the board to soften the soft connection to use the board to the faucet fixed nut screwed down (in the bottom of the table close to the table) to pull the faucet from the basin to hand down the soft connection soft connection and faucet Of the link as long as the rust is not dead, you can screw down the soft connection can be screwed down
The two thin hose into the outer ring can be unscrewed, you circle the shell, there is a shallow slot, you can use the wrench counterclockwise twist off the outer ring, which is good Version of the pupil of the hose can be screwed off, you do some complicated, and perhaps only the hose interface is loose
No need to demolition of other accessories, the two hoses from the angle valve counterclockwise twist, the whole faucet out, and then pay attention to a hose from the bottom of the tap counterclockwise twisted out. Figure is the installation diagram for your reference.
