Explosion-proof ceiling above or in the bridge inside the lighting power there is any requirement
A lot of ways ah! You look at the back of the set-top box, a total of three kinds of interfaces, namely, HDMI digital signal (while transmitting audio and video signals), red and yellow and yellow chicken complex habit of glycosylation moxibustion slim faint handle (red is the right channel, white Is the left channel, the yellow is the video), the color difference signal (red, green and blue, only transmission video), S terminal (single hole four pin, only transmission video). You just put the video to the TV, the audio to the amplifier on the line. . if your amplifier does not have HDMI interface, then put the set-top box HDMI connected to the TV, the set-top box red and white two terminals, connected to the amplifier red and white input terminal, and adjust the amplifier to the appropriate channel The . if your amplifier has HDMI interface, then through the HDMI series on the line, the first amplifier or the first TV will do. . TV set after a lot of them, there is a group of AVOUT output interface, this group of red and white terminals connected to the power amplifier is also OK.
It is generally not recommended to do so. Because the general control line diameter than the power cord to be fine, so it is easy to make the line heat or burn.
HDMI transmission of digital signals, it can be transmitted together with digital sound, video signal. You said with the yellow and white red line (AV sound, video line, its three lines are video and left and right channel audio) is connected to the analog signal. And you find a group of green blue red line is "color input line", it is also the transmission of digital signals (its three lines of transmission only video signal, and no audio signal). Hi-FiLine is the meaning of high-fidelity input (which can be understood as a digital signal input). You do not know how to use your digital sound input interface (coaxial or fiber input). If you do not have the words (if you use the coaxial cable or fiber to connect audio to the amplifier's audio input) can be synchronized in the following way: HDMI high-definition data cable to connect the video to the TV, with the AV signal line to connect the left, Right channel audio signal to the amplifier's audio input. This connection needs to turn off the volume of the TV. You can also use the AV cable from the TV's audio output port to connect the audio signal to the amplifier, so the TV will not be off to the silent.
