Does this ruin my Speakers/tvI want to connect different speakers to my stereo sys., then connect the stereo to the TV. These new speakers were not made for the radio sys. will it affect them. And if iconnect the stereo sys + speakers to the TV, will this affect anything
Home speakers are generally 8ohms if you look at the back of the stereo system it should say next to the speaker connector the ohms load required. If not check users manual/online manual. Similarly check the ohms rating on speakers to see if they match. If they match be sure to connect the polarity correctly and it should work fine. You may notice the new speakers may have a different volume than the old speakers at a given setting on the stereo. this is because speakers have different sensitivity and responsiveness. This is normal. Finally to connect to TV look on the back of stereo of auxiliary input also tape or CD input will work phono will not work. Connect RCA's from your stereo to your TV output you may need a 1/8 headphone adapter.
Look at the back of the stereo or in the manual and see what Ohm range it supports. It will say 8 - 16 ohms or 8 ohms or something like that. Then look at the back of the speakers or in the manual and make sure they match or fall into that range. This is a must. There are ways to correct this if they don't fall into the receivers range, but that's another story. The stereo should have minimum and maximum watts as well as the speakers. Make sure the receiver doesn't put out more watts than the speakers can handle. If it does, you risk blowing the speakers at higher volume levels. Notice that speakers have normal watts and peak watts. If your receiver exceeds the peak watts, that's risky. You shouldn't run your speakers at peak watts for long durations in any case. Email me if you have questions. Good Luck!
Nothing will happen to your TV. Hook up the speakers to your stereo and see if it works without any distortion. (start at low volume - increase volume gradually) There isn't any other way to see if it works, other than trying it out. There is a possibility that you can blow your speakers and/or short out your stereo.
model numbers?? Can't answer without details!
alpine cd + jbl amp + kappas + alpine amp + jl sub sound like a winner to me, yet while u blast ur song u gets some distortion particularly if its heavey metallic song with a selection of of loud electric guitar noise. A small tip tho: ur earnings administration point on the JBL amp could desire to be adjusted like this:: turn that time each of ways down, and ur stereo quantity each of ways up. then turn the point administration on the amp up little via little till u hear ur audio gadget distorting, at that component return a notch and go away it at that placing.
