How can satellite TV receiver position information change?
If installed by the cauldron: please ask you the location of the longitude. And then call up the menu on the star machine guidance function. The latitude and longitude to watch you enter the machine in a satellite. It will calculate the azimuth and elevation parameters. Please show downloaded from the Internet. You can use an adjustable elevation a drill a hole in the center. Out from the hole with a line. Put a button or a small nut knot on line online. To be longer than a protractor. With a long wooden ride in the mouth on the central pot surface must level. The wood. A flat bottom edge on the tight container the wood below.
The pot Yang tune to the machine is connected. The elevation of line after the election of a receiver in the pre station (if the receiver does not have pre stored programs, please open the menu to "increase the program" input to watch satellite program parameters. Please trim around the pan and the tuner, the numerical signal quality to maximum fixed pot and then press the confirm button tuner search should have program) press the remote control receiver on the 'information' button below the screen will appear the signal strength and signal quality information, please. About trim pot and tuner, the numerical signal quality to maximum fixed pot and then there will be a tuner, exit program. Zero line tuner and parallel to the ground.
The present satellite TV receiver has been stored in the aircraft prior to leaving the factory, and it is not necessary to search the station when it is installed. If the installation: connect the line to the TV pot to adjust to the AV mode, press the menu button to open the receiver (or directly by adjusting the star key or F3) and then transferred to the system settings and press the confirm button to enter the password again '0000' or '9999' to press the enter key, see sub menu "installed and in signal detection. The lower right corner of the screen is two line display signal strength and signal quality for two color, and then around the adjustable elevation and side pot placed southwest slowly up and down, the numerical signal quality to maximum fixed pot and see TV tuner, can press the eject button (because the receiving machine factory orders have existing machine pre season inside, not recovery) according to factory settings and automatic search, because the satellite is not aligned in the pot when absolutely not search programs, but the original pre program parameters will also be removed.
