How can the inner and outer rings of deep groove ball bearings be separated?
Take your coat cutting cut, or the inside of the bead frame got off, the ball fell to dial together
With a hammer smashed, only violence
First remove the cage and then divide the two:The first is the rolling body is relatively long, the rolling body to one side, leaving only one on the other side, and then squeeze the outer ring, elastic deformation of the moment in the outer ring, a rolling body out, the rest of the rolling body basically can be used directly to get out of handThe second is the rolling body is relatively small, then the inner ring to one side pressure, the other side of the left out of the gap, you can directly take out the scrollNow let me introduce you to the installation of bearings. I'm sure you can see something out of it:Angular contact bearing: the retainer is attached to the inner ring --- put the steel ball - the fixed steel ball (specifically how not to be fixed) - press in the coat (larger, generally hot)Spherical roller bearing holder sheathed on the inner ring - knock on roller (with a few grains to be placed in the empty coat) into the jacket -- ---- roller according to the fullNeedle roller bearing: no retainer: apply grease to the outer ring groove (easy to press the needle) ---- place the needle roller (with an inner sleeve and press the upper sleeve)With retainer: retainer in inner sleeve ---- press on needle ---- (with inner sleeve and press upper sleeve)No inner or outer coat: press the needle roller on the retainerTapered roller bearings: roller placed on retainer - press inside sleeve - shrink retainer - put on coatJoint bearing: sleeve broken: press inside ball cheng90 degrees into outer coatOuter milling installation opening: inner ball into 90 degrees into the coatDeep groove ball bearing: insert the ball into the inner coat --- put on retainer -- riveting
