How do electronic saws operate?

Answer:

In front of the floating table, note the action should be smooth, so as not to cause scratches, not to hit the side of the foot and clamp;6, cutting the workpiece once placed, start running the program after do not enter, to avoid pressure wound cut;7, the host hand pay close attention to equipment operation, abnormal sound, abnormal vibration and other abnormalities, timely downtime check, and report to the leadership or equipment maintenance;

According to the cutting thickness adjusting operation saw sawing speed adjustment, in the range of 10 - 80m/min, sawing a slow speed when sawing, sawing hard wood should be reasonable to reduce speed, cutting board within 25mm sawing rate should be between 70-80M/min and 25-60mm within the saw cutting speed should be 50-70M/min, cutting 60mm to the maximum thickness of 80mm is the fastest of not more than 40M/min so as to avoid the damage caused by equipment saw blade swing and avoid sawing quality problems, adjust the sawing rate to achieve the best production effect;

This machine main saw uses the diameter 380mm saw blade, the main saw blade rises to 95mm, the biggest sawing thickness is 80mm, strictly forbid to exceed the limit sawing, the over limit sawing will result in the damage of the equipment or saw blade;

1, after feeding, device program-controlled push plate device should not run too fast, program-controlled push plate device (for operators) speed greater than 25 meters / minute, will automatically close the push;2. The maximum pushing height of the programmable push plate is 80mm, and the overrun is prohibited;

When the saw blade is replaced, especially the new saw blade, the saw tooth protection film must be removed, and the saw blade can be installed. If the adhesive film is not removed, the sawing resistance can be cut, and the equipment and saw blade will be damaged;