How do you close the wallpaper?
The reason is that there is moisture in the air, the wallpaper will become warped when the time is long, and the building materials market has layering to solve the problem.If you want to say what a letter can be, the box can also, of course the best nail glue and nail, usually with a nail box, before in the frame with steel row nail plate and nail box using the nail, the nail is fine, is not obvious, the best way is to with the wood board nailed on the brace, and then paint on the panel, you can paint or free.
It doesn't have to be sealed. If you want to seal it, anything is OK and the box is ok.Of course, the nail is the best. Glue and nails are usually used.Wallpaper construction process and construction technology1. grassroots treatmentPaste before, should be on the surface of the base substrate or dirt, clean the dust, efflorescence parts with dilute acetic acid and cleaning nine percent. The base may not have flying thorn, pitting, sand and cracks, yin and yang angle should be straight. The surface is smooth and sticky.After the grassroots cleaning, in the grass-roots to play putty, dry sandpaper polished.2. brush primerPaint with an environmental varnish, solution, etc on the base surface.3. part elastic lineFirst of all, the interior is facing indoor, dead angle, according to wallpaper width row, Yang Kok should be wrapped angle, overcast corner to overlap, and according to the plan to play the vertical line, and number marked, as a sticky line.4. cut paperAccording to the wall frame size, cut the paper according to the requirements on patterned wallpaper pattern, the corresponding number two, she set aside 30---50MM volume cutting, flat.5. brush adhesiveThe table will wipe the back cut wallpaper to flat, with a flat brush or roller coating, and press the upper 1/3, lower 2/3, rubber face rubber surface after folded into a cylinder by post. (ten, wall felt back glue, in order to avoid the pollution of positive. Glue only to the wall.).6, stickyThe brush glue after the wallpaper launched folding the top part of posts on the wall, along the vertical datum line (horizontal) post wall (ceiling), with a plastic scraper or brush to scrape out, and she bubble adhesive, with a clean towel to wipe seam wallpaper, wallpaper knife to cut the number she part.
It doesn't have to be sealed. Anything is OK if you want to. The frame bar is ok. Of course, the nail is the best. Glue and nails are usually used. The bar nails should be placed under the bar at the beginning of the bar. Then nail the frame and use the nail. Small nail. Not obvious... The best way is to use nail board brace. Then the upper panel. Ready to paint or paint free..
