How do you stick carbon fiber stickers on your car? Also, when there is a large amount of concave, how should I do?
1, will need to paste the clean surface in the glass of water please spray in the paste surface ready to paste paper before (after cleaning the body, the body will be in the water with the watering can to put on), is mainly used to reduce viscosity, easy to adjust position sticker;2, determine the need to paste position, together with the car from right to left to or from top to bottom [] lifted aside and wipes the pressing in the car on the table, then, side by side stick cloth pressing, while Jiedi paper;3, meet the door handle or bar according to the material and cut into or set off;4, timely adjustment, the general position of the graphics to determine the correct, with scraper repeatedly scraping water and bubbles, use scraper when from right to left oblique scraping;
Paste position 1, clean body, conditional can use fiber shedding cloth dipped to scrub with 50% alcohol or isopropyl alcohol or acetone, also used soap and water; the surface of the solvent cleaning solvent to evaporate completely behind the available paste;2, in general, the side of the stick slowly, while whiletoolsevenness, while Jiedi paper;3, if the car width is less than 10 cm, and the sticker all tear paste. But be careful not to happen accidentally sticking or falling off the ground and sticking up the dust;4, cleancloth [such as phone cards or credit cards in the film fewrampuntilno or scraping a few; not until the bubble inside the car stickers, 24 hours do not wash or exposure.
