How do you use SolidWorks to mesh gears? How do you choose fit?

Answer:

4, last modified, with the rotation speed is correct, there may be no initial position on the tooth tooth, with overlapping, even after the rotation speed is correct, but always overlap, the first with the "compression", a manual drive gear to rotate, until the teeth do not overlap between the unlock with compression

3, the possible transmission ratio and movement speed is not accurate, may not be elected to the circle, resulting in, to make changes. When the left circle is to choose the toolbar will correspond to two digits, respectively, pitch diameter of choice, if you choose the addendum circle or other what, this value is correct, but can modify the handwriting input. When adjusted, the speed of rotation is correct.

1, first of all, the two gear positions, such as the distance between the two axis, as well as the end face coincidence (or how much distance);2, the most important, is to choose mechanical matching, choose the pitch circle of the two gears (if you build in the gear model has drawn is the best, then no painting also never mind, you can choose the addendum circle or the root circle is the choice of a small Duan Yuan arc of the tooth) at this time, whether you choose the preliminary round, the match has been done, you drag a gear, a gear will follow the move;