How does a crane wireless receiver match a new remote
The crane wireless receiver matches the new remote: Black (1) and (2) brown lines to connect power, the power of the orange line by contactor, red line the main contactor coil, yellow and green two wires and contactor, blue, and purple two wires connect east and west direction contactor, gray, white south and north direction contactor, pink is the standby line.
If it's a simple jumper, just disconnect the original remote and set the new remote control to the inside of the code dial (or jumper).
If it's a simple jumper, just disconnect the original remote and set the new remote control to the inside of the code dial (or jumper). First look at your wireless receiver decoding chip is what type of crane wireless receiver receive frequency is much higher, then find out and the decoding chip of remote control chip is what type of form a complete set, again to buy is the chip of the remote control, and transmitting frequency and crane wireless receiver. In the case of the case, you might want to learn the code or the dialing code. Do these points, matching success rate is not high, because it contains a lot of professional knowledge, conditional word get professional with the master of the remote control is well solved.
If it's a simple jumper, just disconnect the original remote and set the new remote control to the inside of the code dial (or jumper).
The remote control is a device for remote control. Modern remote control, mainly by integrated circuit panel and used to generate different messages (communication of message definition: composed of a set of interrelated meaningful symbols, able to express a great sense of complete information.) The button is made up of. The remote control of the passenger door is to use the latest technology encoding decoding, to use the flash mode to control the door pump solenoid valve to reach the purpose of switching the automatic door. The bus (bus, China and Pakistan) remote control, close the door, avoid the annoyance that the driver needs to get into the door every time. The main components of the remote control are infrared light-emitting diodes. It is actually a special light emitting diode, due to its internal material differs from ordinary light emitting diode, thus exert a certain voltage at both ends, it is infrared instead of visible light.
