How does ice maker get out of the water but not make ice?
Four, ice machine leakage: 1, the intake valve to provide water disk, too much water. 2 、 the connection pipe is broken. 3, fault. 4, water level float valve fault.Five, wet Bing Bing film is not hard: 1, environmental temperature is too high, especially in the summer will have a kind of situation. The machine repaired 2, add refrigerant. 3, ice separator water supply is too large. 4, press power shortage.Six, excessive noise: 1, ice maker fan fault. 2, reducer fault. 3 、 compressor noise.Seven, boot reporting system failure: 1, phase sequence problems. 2, the power supply system failure. 3 、 control panel faultEight, water shortage alarm: 1, water supply joint, filter net plug. 2, water pipe plug. 3 、 inlet valve block. 4 、 drain valve leaking. 5, pump fault, click on the link
First, the machine running, but not out of ice: 1, water disk water is not enough or no water. 2, reducer failure or deceleration motor. 3, system failure, ice jam. Dirty block, etc.. 4, ice machine leakage of snow, the pressure is not enough, 5, ice thickness is not enoughTwo, reduce ice production: 1, capillary or expansion valve plug. 2, the system moisture is too high, there is a slight ice jam. 3, ice machine condensation system is blocked. 4 lack of refrigerant or leakage. 5 、 the evaporator is dirty.Three, compressor intermittent work: 1, voltage is too low. Check the power supply. 2 、 handing over contact is not good. 3, system pressure protection. 4 compressor starter fault. 5, condenser is dirty, high voltage protection.
For many reasons the ice machine not ice, but cannot do without the ice machine itself can be the first observation of hardware, abnormal situation, and finally determine the location of the fault point, not ice the crux of the problem, so the shrinking area can quickly and accurately find the point of failure. The following is a summary of the ice maker's failure analysis:
