Home > categories > Lights & Lighting > LED Tubes > How does the T8LED light tube replace the fluorescent lamp tube
Question:

How does the T8LED light tube replace the fluorescent lamp tube

How does the T8LED light tube replace the fluorescent lamp tube

Answer:

Step 1: use a screwdriver and a pliers to disconnect the ballast from the wire. But my home is the sun lamp base of zhengtai, the quality is too good, it took 10 years. I didn't even get down to the ballast, which was stuck in a full thick iron base, so I disconnected the wire. The wire that disconnects from the ballast is sure to have two heads, just to disconnect the connection. There is a lot of direct skewers of black tape, some of which use that connector and screw the two wires together. It's the same thing. This is the connector that is used in this case. Disconnect the regenerator, remove the wire and then rewire the two broken wires together and attach the black tape (which is the insulating tape). Put the base back to the original. Install the fluorescent tube, and remember to place the head of the European logo on the base of the current. And when you put it in place, it's going to be OK.
I just changed it. I bought a LEDT8 type of fluorescent tube 1 meter 2. 16 watts is basically equivalent to the ordinary energy-saving fluorescent tube 60 watts. It's very bright and bright, and you don't need a flash. But there are brands that don't have to take down the ballast, and you have to consult the person who sells your LED tube. The ballast and the regenerator are broken down, and the different brands are different.
Tube at both ends a firewire, on the other side is zero, the two feet per head are connected together, by one or two can be, if with neon bulb starter, starter can be twisted off, then remove ballast two joint together can change LED bulb.

Share to: