How is the center of the processing center?
2. Turn to handwheel mode For example, to find the first Y to find the edge of the workpiece to the middle of the first close to the Y side of the end, such as the first close to + Y start the first hand wheel speed is adjusted to 0.1 is 10 when the fast when close to the edge
Use the edge finder to install the edge device and then MDI mode input S500M3; sure to confirm the speed and then start there will be life-threatening if more than 0 input S5000 did not pay attention to the edge of the edge of the direct rejection of the consequences are very serious!
2. Turn to handwheel mode For example, to find the first Y to find the edge of the workpiece to the middle of the first close to the Y side of the end, such as the first close to + Y start the first hand wheel speed is adjusted to 0.1 is 10 when the fast when close to the edge
To the safe position and then close to the other end of the Y-Y to the beginning of the first hand wheel speed to 0.1 speed close to the workpiece concentric when the hand wheel speed adjusted to 0.01 slowly close to the workpiece to see the edge of the erection of the edge again
