How is the hollow tempered glass mounted on the channel steel?
Installation method of hollow toughened glass:1, glass cutting: the original glass is usually colorless float glass or other colored glass, sun glass, tempered glass, laminated glass, the thickness of 3 mm to 12 mm, the glass must comply with the provisions of a superior product grade, GBll614, can be used after passing inspection. Glass cutting may be done by hand or by machine, but it shall be in accordance with size requirements. Such a procedure of workers in the operation process, should always pay attention to the glass surface without scratch, er uniform, no bubbles, slag and other obvious defects.2, glass cleaning and drying: glass cleaning must adopt the machine cleaning method, because manual cleaning can not guarantee cleaning quality. Check the glass without scratching before cleaning. In order to ensure the adhesion between sealant and glass, it is better to use deionized water. In addition, in order to ensure the use of water recycling, water conservation, water filtration can be used to ensure long-term use. After cleaning the glass to light through the inspection, inspection of glass surface is water, water stains and other stains, if there is water, water stains and other stains, need to machine running speed, heating temperature, air flow, brush clearance adjustment, to achieve the effect until well done. After washing the glass should be assembled within 1 hours into a hollow glass, in addition to ensure that glass and glass between the friction and scratch, it is best to have semi-finished glass storage car, between the glass and the film.3. The assembly of rubber strip type insulating glass and aluminum strip type insulating glass. Adhesive tape type insulating glass assembly:
Hollow two pieces of glass, there are 4 faces, from outdoor to indoor is defined as 1-4, Low-E glass film surface can only be in the cavity, that is, can only be second or third.Colorless, highly permeable Low-E is placed on third sides (Low-E glass indoors), colored on second sides (Low-E glass outside).In order to prevent the broken glass debris, doubling down side must. Because qualified laminated glass is not damaged when the debris generated, is still able to maintain its integrity.
Hollow two pieces of glass, there are 4 faces, from outdoor to indoor is defined as 1-4, Low-E glass film surface can only be in the cavity, that is, can only be second or third.Colorless, highly permeable Low-E is placed on third sides (Low-E glass indoors), colored on second sides (Low-E glass outside).In order to prevent the broken glass debris, doubling down side must. Because qualified laminated glass is not damaged when the debris generated, is still able to maintain its integrity.
