Shell on the upper left corner and the lower right corner of the two screw holes. Why is the upper left corner screw hole designed to have only half a circular arc? Installed up the screw can only pressure a little bit edge. Fixed unreliable
Emergency repair method can be sticky with glue stick, bare part wrapped with green shell paper fixed.
Xiongtai switch power on the bottom of the reverse look up, so that those wiring lines up, the line also pick up, then you say the upper left corner of the screw hole (note that it is not a screw hole hole), do not change Into the lower right corner of the screw through the hole, you screw the first screw on the floor, the switching power supply is not a long hanging firmly firmly fixed on the top and then simply fix it, it is very reliable.
That half of the hole is actually easy for users to disassemble the design, half of the hole facing down, both good and easy to unload, Oh!
Side also has a fixed position to install, increase the installation of 90 ° bracket.
L: then 220v AC line of fire
N: then 220v AC zero line
FG: then the earth
G: DC output ground
+ 5v: output + 5V point of the port
ADJ: is the output voltage within a certain range, the switching power supply output voltage is the original factory is fixed, that is, the nominal rated output voltage. Set this potentiometer allows users to the actual use of the situation in a smaller The output voltage is adjusted in the range. It is not necessary to adjust it in general.
