Home > categories > Energy Products > Solar & Renewable Energy > How long does it take to fill the water
Question:

How long does it take to fill the water

The Chinese New Year back home, the solar water in all dry, back in the new year after the first solar water, the results on the twenty minutes, the water level of the water level of the solar energy meter or the former, and no water before. What is the reason?. What's going on?. Thank you everyone.

Answer:

4, the solar water heater with high efficiency, in the summer sunny weather conditions, less than two days water temperature can reach the boiling point, if a long time without water, such as travel, tourism, to make the water a long time at high temperature and high pressure condition, will accelerate the aging of the sealing ring, accelerated aging, polyurethane shrink, sometimes the exhaust is not smooth, too much pressure will make the tank expansion bad, will shorten the life of furring, water tank. Therefore, if you are not at home for a long time, you should arrange for others to put hot water on the cold water, or in the vacuum tube collector placed on the cover to block the sun, to go home and then remove.5, take a bath, if the water in the solar water heater has been used up, but people are still not clean, then can last a few minutes in cold water, cold water and hot water by using the principle of sinking floating, the hot water in the vacuum tube of the ejector can then take a bath.
Solar heaterWater supply method for solar water heater:1, if you are installing the overflow pipe induction, the user can first open the stepless regulating valve or ball valve to function in Sheung Shui Sheung Shui, solar water heater, solar water heaters generally an overflow pipe, an overflow pipe according to the judgment whether the drainage water filled, also can be equipped with a water level controller, water full automatic alarm, according to alarm discrimination.2, if the installation of the integrated valve, the user should open the water valve, tap water through the water pipeline began to solar energy for water, water full closed automatically, when we use the water off the water valve, open the water valve to switch or mix.3, if the installation of water supply control system, the user first according to the control system of the water key, the solenoid valve to open, to pay for the solar water, when the water level set up, the control system to stop the solar water supply.
In daily use, try to ensure that a sunny day to heating water heater water after such a long time, the sunshine can ensure the water temperature to the maximum, if the night run out of water immediately after the water, it is easy to effect of water temperature on the morning of the second day, should water again later. Winter, spring evening after the bath, if the water heater tank, there are half of the temperature of 60~70 degrees Celsius, the water filled the night, to prevent excessive heat loss.
About half an hour.Solar water heater water time, it is best to choose in the case of non high temperature air drying water, the best time for sunrise or two hours after sunset water. Because our vacuum tube using the world's most advanced automatic production line, high vacuum, is 100 times the national standard, good insulation effect, high thermal efficiency, fast heating. Due to the high temperature of the air drying, if at high temperatures to solar water, because the temperature difference caused by the explosion. When the vacuum tube is in the air, the temperature in the pipe can reach about 250 DEG C, so the water in the water tank or the first water supply must be carried out before sunrise or after sunset.

Share to: