Recently wanted to buy back the power to go back the line line, is now a little that they need the shortest distance back line, on the other hand, a lot of power will not take the initiative to mark their long, very annoyed, for!
Just now for a classmate to answer, say again side:The height of the back of the tower is very critical. If a tower back line height is 500MM, and has a complete line of the back hole, then back line is the longest distance is from the bottom to the top of the power line of the back hole CPU 4+4PIN power supply line of the back hole distance is the longest. It is at the bottom of the total line of the back hole distance to the upper right corner of the motherboard 20+4PIN is second SATA/IDE long, the other is due to the power supply that the distance is also the case, so these used in power supply chassis in sure enough.
Therefore, whether you can go back, the key depends on the length of the two power lines, CPU, 4+4PIN and motherboard 20+4PIN, and this length must not be higher than the overall height of the chassis. If the overall height of the chassis is 500MM, then the distance from the bottom end of the back line to the top is probably about 450MM. In addition to the power input to the low back line hole distance and the top 4+4PIN back line hole to the actual power supply position of the motherboard, the general distance is still more than 450MM+50MM. 550MM is the most secure. 20+4PIN over 450MM is also more insurance.
Of course, certainly some people recommend Antec, those will do, as long as they like, sell, and then you will buy. I just recommend a few more reasonable brands, I personally feel good. Remember, the key word: CPU power is more than 550MM, the motherboard power more than 450MM compared to insurance. Pick the ones marked with length to buy them!!!!!!!
If you want to go back line, I recommend Antec model series, its 4+4PIN up to 60 cm, to deal with most of the tower box is no problem.By the way, some players are better off doing so in order to be able to go back on the line and buy power extensions. It's easy to burn wires, because most of the extensions on the market aren't good enough.
Whether the power supply can go back depends on the length of the 4+4PIN and 20+4PIN lines, especially the length of the 4+4PIN line. For most of the tower chassis, the length of the 4+4PIN line is more than 50 centimeters.On the specific length of line, you are right, the power nameplate is not marked line length, it is best to go to the power supplier's official website to inquire about it.
