How many grams of 200t injection molding machine?
Heating part energy saving: heating part energy saving, mostly using electromagnetic heater energy saving, energy saving rate is about 30%-70% of old resistance ring.1. compared with the resistance heating, the electromagnetic heater has a layer of thermal insulation layer, and the heat energy utilization rate is increased.2. compared with the resistance heating, the electromagnetic heater acts directly on the tube heating, reducing the heat transfer and thermal energy loss.
Each injection molding machine is standard with three types of screw, mainly to see requirements, the smallest less than 200g, the largest more than 300, general ABS with medium-sized screw, PA, PC with small screw, PP with large screw.Energy conservation:The energy saving of injection molding machine can be divided into two parts: one is the power part, and the other is heating part.Energy saving: most of the power inverter, energy saving way is through energy saving more than the actual motor, such as motor power is 50Hz, and you actually need only in the production of 30Hz is sufficient to produce, the extra energy is wasted, the inverter is to change the output power of the motor to achieve the energy-saving effect.
3. compared with the resistance heating, the electromagnetic heater heating speed more than 1/4, reducing the heating time.4. compared with the resistance heating, the electromagnetic heater heating speed, production efficiency is improved, so that the motor is in saturation, so that it reduces the high power and low demand caused by the energy loss.The above four point is to fly such as electromagnetic heater, why can injection molding machine energy saving up to 30%-70% reasons.
