Home > categories > Home Appliances > Heat Pump Water Heaters > How should the air heater be properly used?
Question:

How should the air heater be properly used?

How should the air heater be properly used?

Answer:

Second: regular inspection and maintenance system, safety valve, water tank, water level controller and exhaust device is working properly, so as to avoid air entering the system to reduce the volume of water, which affects the reliability of heating capacity and unit operation set. At the same time can not be ignored to check whether the water pump, water valve is working properly, water pipes and pipe connections are leaking. In addition, it is necessary to check the working conditions of all parts of the unit regularly, check whether there is oil pollution in the pipe fittings and the inflating valve of the machine, and ensure that the refrigerant of the unit is not leaked. When the actual water temperature of the air energy heat pump water heater is not consistent with the display value of the control panel of the unit, the temperature sensing device can be detected whether the device is in good contact.
3, if you go out or stay away from home for a long time, remember to cut off the power supply, so as to prevent water from circulating continuously heating, it is the main factor of power consumption.4, the usual use of the process, pay attention to the daily maintenance of air heater:First, keep the cleaning frequency, water filter water heater installed outside should be cleaned regularly to ensure a clean water system in order to avoid damage to the host unit caused by dirty filter plugging; note also that the place is in the cleaning of the condenser's suggestion, every two years using the 50 DEG -60 DEG, concentration of phosphoric acid solution to clean the condenser heat 15%, start the host with the circulating water pump 3 hours after cleaning, cleaning with tap water 3 times. Cleaning of condenser with corrosive cleaning liquid is prohibited. If the downtime is long, the water in the pipe line of the unit should be discharged, and the power supply shall be cut off, and the protective cover can be sheathed.
Before the first use, must be filled with cold water, water outlet can be, and if the amount of hot water in the home and the purchase capacity enough, it is recommended for users to use economic mode heating.2, you can also adjust the reasonable boot time to reduce power consumption. It is recommended that the users run from 12 noon to 4 p.m., with the highest thermal efficiency and the shortest heating time.

Share to:

Hot Tag