Home > categories > Machinery & Equipment > Edge Banding Series > How should the reinforcing rib of the reinforcing bar of the cap be arranged?
Question:

How should the reinforcing rib of the reinforcing bar of the cap be arranged?

How should the reinforcing rib of the reinforcing bar of the cap be arranged?

Answer:

Just like the bottom bar end housing, in cap around layout, general single two-way reinforced net
Then you have to see the design requirements. If not, refer to the 85-91 page of the 11G101-3 atlas, depending on the type of the cap
First, according to the specifications, as follows:Specification: 4.2.3.2 under column independent pile cap workingreinforcement should pass configuration. The rectangular reinforcement plate should be evenly arranged according to the direction of both sides. The diameter of the steel bar should not be 10 small, and the spacing should be 100 ~ 200mm. For the three pile caps, it should be evenly arranged according to the direction of the three plates, and the three steel bars intersected at the bottom shall be within the scope of the column section. ? ?Two, reference specification:Technical specification for building pile foundation and standard atlas of reinforced concrete circular pile caps.

Share to: