How the solar controller wiring,
The lid open, there is a row of posts, the above will mark the solenoid valve, the signal line red or yellow or yellow, blue and green, there may be accompanied by tropical, electric heating, the corresponding connected on the line.
Controller (English name: controller) refers to the order in the order to change the main circuit or control circuit wiring and change the circuit resistance value to control the motor start, speed, braking and reverse the master device. It consists of a program counter, an instruction register, an instruction decoder, a timing generator and an operation controller. It is a "decision maker" that issues a command to complete the coordination and command of the operation of the entire computer system.
Power cord - usually with the controller with a three-pin plug power cord, has a good controller; sensor line - two lines and four lines, according to the label with a plug or terminal connected to the controller; solenoid valve - Two, according to the label connected to the controller; electric auxiliary heating line - three, according to the label connected to the heating bar.
Open the panel below the lid, which has a post, there are marked, facing the annotation is what to pick on the line!
Carefully follow the instructions on the wiring
