A. Preparatory work and installation of architectural membrane pasting: 1. Preparations before installation a) Learn the specific conditions of the window to be pasted membrane in detail, and estimate specific items for site cleaning, and the size and quantity of the window membrane needed cutting; b) Determine the construction?method according to the window membrane type chosen by the customer and characteristics of the the glass; c) Check whether the installation tools are normal, and check if the "blade" of the water wiper is flat and smooth, and if there is any gap existent. Check if the cleaning scraper knife is sharp, and if there is any gap or sawtooth existent; d) Check if the cleaning and installation towel is clean, if the waterproof membrane is clean and intact; e) Prepare the film-on and cleanout fluid well; 2. Installation of window membrane: A. Advance preparations for the construction site. a) In the construction site, remove the curtains, blinds, and all other objects near the window carefully, and make them go back to the original state when the window membrane installation is completed. Try to leave more space for equipment placement. If the construction site is located within an office or store, please make sure that the cleaning work in advance will not interfere with the customer's normal business operations; b) Do a good job in on-site waterproof and cleaning, laying of waterproof membrane, and work overalls and shoe covers wearing;
You can find a lot of knowledge about film pasting on the Internet, but it is trivial and not very practical. Customers often ask me this question and I sum it up. 1. Cut the film well before film pasting. The film cut area is usually more than 1-2cm than the used area (supplies). For film pasting, water is first needed, and filtered water is the best. Add detergent (liquid detergent is ok, and 7 drops of liquid detergent should be added to a pot of water for the ordinary sprinkling can) into water to clean up the glass, especially its four corners. After cleaning it up, sprinkle the water with liquid detergent added onto the glass before film pasting to keep the glass moist and lubricated. 2. Tear off the release liner. Sprinkle the water with liquid detergent or lubricant added on the film while tearing off the release liner. Don't make the film stained with dirt, and then quickly attach the film to the glass and put it away in proportions. 3. Attach the release liner to the surface of the film to prevent the film from scratching when the film is scraped. 4. Use a soft scraper blade first to scrape the visible excess water. When wiping off water, you should do it in a certain order, and it is best to wipe off water from the center toward the parts around. 5. When the inside water is invisible, you can use a hard scraper blade to squeeze out all the inside moisture. 6. Tear off the release liner and cut off the excess film with a blade. 7. Wait until it is dried naturally and film pasting is completed.
