How to adjust the bag machine knife
When the use of a period of time after the plug iron gap increases should be immediately adjusted, then the first release of the nut, a little plug into the plug iron adjustment screw to the appropriate gap so far, and with a spike check, the gap should not be greater than 0.02mm,
When the knife on the line to the bottom deadline, and the knife should be completely closed left and right, such as the right side has not yet fully closed, it should adjust the connecting rod adjustment nut, so that the knife slightly down, after adjustment, the pin tighten the nut.
After adjusting, to lock the nut, to prevent loosening.
Good), pull the paper at both ends of the degree of compression, until about equal.
Weld knife adjustment method: in the bearing seat pad with a thin paper, hand rotation of the body box of the big hand wheel, so that the welding knife at the bottom dead center, loosen the nut, adjust the nut (Note: rod adjustment nut factory
