How to install and set up bike riding friends is always the cost of thinking, this paper will discuss today the installation and setting method of bike, teach you how to install the bike. Said relatively simple, I hope the majority of riders can participate in the discussion.
Following the start of the first step, the base mounting table.Make sure you hope will be installed in the table or the office. The manufacturer defaults to installing it. If you want to install it, you don't need to adjust it. If you want to install it, you need to use a screwdriver to remove the base, rotate 90 degrees, and then install.Base on the back of a bubble gum, tore the yellow rubber surface can be pasted on the handlebar, and then use the rubber band around the handlebar of a circle, a slot in the base on both sides of the table, the base firmly fixed on the handlebar.
The data line is connected to a sensor, the other end is the base table. Induction magnet and two rubber bands (used in large fixed sensors, small fixed on the base, the back will be used), there are a few root line is not detailed, directly to the installation steps of table.
Next, install the sensor head.The induction line is wound around the brake line until you need to install the sensor. The inductor can be mounted in the middle of the front axle and the brake.The installation method is similar to the installation of the base, the location of the sensor will be selected, and then press it with your fingers, then use a large rubber band around the rod, a rubber band buckle in the sensor slot.
