How to adjust the electric hoist brake?
Remove the end cap, spin off four screws fixed adjusting nut, using a wrench to adjusting nut screw clockwise to limit position, again a counterclockwise circle, and then to the bolt fastening.
If the spring is too long and the spring is insufficient, please change the spring to solve the problem. Is it caused by chronic overload? Turn the brakes, and turn the big nut behind the motor to tighten a loop. If you can't, the spring doesn't work!
The main explanation is that the electric block brake is achieved through the motor After you have adjusted it, try again The main shaft of the conical rotor motor is normally at 1.5 mm, the braking effect is optimal. The adjustment is as follows: Remove the end cap, spin off four screws fixed adjusting nut, using a wrench to adjusting nut screw clockwise to limit position, again a counterclockwise circle, and then to the bolt fastening.
