How to adjust the hydraulic bending machine
if the workpiece angle at both ends of the non-disagreement, can loose the nail, the convergence rod left, off the left and right rotation of the convergence, into the hand wheel (up or down) change the mechanical limit of the end of the interval,
The size of the workpiece angle to trim the gap. You can also use the handwheel to stop the fine adjustment, the adjustment value is displayed by the calculator, each increase and decrease the number of single digits is 0.1mm (0.1mm / turn)
The adjustment of the upper and lower mold gap (the slider must stop at the top dead center) a, operate the button on the lower right button box of the work table, according to the direction indicated by the sign, the initial adjustment gap should be greater than the thickness
Adjust the position of the impact block II, so that the rising slider can stay in the required top dead center position, which can shorten the slider stroke interval, reduce the working cycle time, thereby increasing the consumption rate.
